Repair And Rehabilitation Of A Faulty Refrigerator
FLUSHING OF THE CONDENSER
The refrigerant gas let into the condenser through the compressor and the vacuum pump was connected to the condenser to absorb dirty.
REFILLING OF GAS INTO THE COMPRESSOR
Gas was refilled into the compressor due to shortage of gas and it was filled inside the charging value and refrigerant.
CHANGING OF DRIVER STRAINER DUE TO BLOCKAGE
The driver strainer was change due to blockage with the help of oxygen and acetylene welding.
SPRAYING OF THE FRIDGE
The compressor was put on and the compressed air through the holes to the gun due to high pressure inside the tank. The air then forces the point out of the gun for spraying.
NOTE: Preview the following Table of Content before you download the full content. WYSIWYG – What You See Is What You Get.
Title Page ii
Release Page iii
Transmittal Page iv
Approval Page v
Abstract vi
Acknowledgement vii
Dedications viii
Table of content ix
CHAPTER ONE
Introduction 1
CHAPTER TWO
Literature Review 3
CHAPTER THREE
Tools Used 8
CHAPTER FOUR
Final Test and Sequence of Opera 11
CHAPTER FIVE
Conclusion 14
Reference 15
Appendix Two 16
This “Repair And Rehabilitation Of A Faulty Refrigerator” file contains 5 Chapters, 25 Pages and 2,471 Words.
The author of Repair And Rehabilitation Of A Faulty Refrigerator is written at the front page of the downloaded file.
To download this Repair And Rehabilitation Of A Faulty Refrigerator full file, click on “Download File” on top of this page and follow the next.