Design And Construction Of Battery Charger
This project which consists of four chapters deals extensively with the design and construction of a battery charger which is capable charging a 12 volts, battery.
The first chapter which is the introductory chapter goes a long way in defining the battery charger and explaining of the mode of operation.
The second chapter went further to explain each component part of the battery charger. This ranges from:-
1. The transformer
2. The rectifier circuit
3. The filtering stage
4. Voltage regulation
5. Comparator
6. Thyristor
7. Resistor
8. Diode
9. Relay
10. Zener diode and
11. Light emitting diode (LED)
The third chapter explains more about the Testing Sensing and switching processes in the charger. It also gave the list of components and the circuit diagram of the battery charger.
The concluding chapter being fourth, tells us more about the circuit arrangements and the construction of casing and finally the overall cost analysis.
NOTE: Preview the following Table of Content before you download the full content. WYSIWYG – What You See Is What You Get.
Title Page
Approval Page
Dedication
Acknowledgement
Abstract
Chapter One
1.1 Introduction
Chapter Two
2.1 Block Diagram Of Battery Charger
2.2 Transformer
2.3 Ac To Dc Converter
2.4 Filtering
2.5 Voltage Regulation
2.6 Comparator
2.7 Thyristor
2.8 Resistor
2.9 Diode
2.10 Relay
2.11 Zener Diode
Chapter Three
3.1 Network Synthesis And Testing
3.2 Power Supply
3.3 Sensing And Switching Circuit
3.4 Battery Condition Test
3.5 List Of Component Values
Chapter Four
4.1 Conclusion
4.2 Cost Analysis
Bibliography
This “Design And Construction Of Battery Charger” file contains 5 Chapters, 35 Pages and 3,427 Words.
The author of Design And Construction Of Battery Charger is written at the front page of the downloaded file.
To download this Design And Construction Of Battery Charger full file, click on “Download File” on top of this page and follow the next.