Design And Construction Of A Single Phase Power Supply For A Three Phase Induction Motor
This research work on “Design And Construction Of A Single Phase Power Supply For A Three Phase Induction Motor” is available in PDF/DOC. Click the below button to request or download the complete material
ABSTRACT
These 3 phase motor is supplied with 3 three-phase AC supply and is widely used in ships for heavier loads. This research is purposed to established a new method is simple and good to operate the three phase induction motor on single phase power by using capacitor. The object used in this research was three phase induction motor that has the standard of 2 HP, 440 volt, Wye connection, 2 Pole, 50 Hz, 3000 RPM, 3.08 Amp. The result of this research showed that the method could work well to control the motor to operate properly to load 85% of the full load. In general the motor has better performance when operating on single phase power system in all load cases (low at high load). The motor could operate with power factor close to unity, higher speed and better efficiency. The motor operated with higher current harmonic distortion with low loads but lower current harmonic distortion at high loads. There for it is very good to operate the motor at high load up to 85% of its full load.
TABLE OF CONTENTS
COVER PAGE
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWELDGEMENT
ABSTRACT
CHAPTER ONE
1.0 INTRODUCTION
1.1 BACKGROUND OF THE PROJECT
- PROBLEM STATEMENT
- AIM OF THE PROJECT
- OBJECTIVE OF THE PROJECT
- PURPOSE OF THE PROJECT
- SIGNIFICANCE OF THE PROJECT
- APPLICATION OF THE PROJECT
- LIMITATION OF THE PROJECT
CHAPTER TWO
LITERATURE REVIEW
- OVERVIEW OF INDUCTION MOTOR
- HISTORICAL BACKGROUND OF INDUCTION MOTOR
- THREE PHASE INDUCTION MOTOR CONSTRUCTIONAL REVIEW
CHAPTER THREE
- METHODOLOGY
- DESIGN OF INDUCTION MOTOR
- CAPACITOR CIRCUIT TO THE COIL
- SELECTION OF CAPACITOR
CHAPTER FOUR
- EXPERIMENTAL RESULT
- APPLICATION OF 3 PHASE INDUCTION MOTOR
- ADVANTAGES OF INDUCTION MOTOR
- DISADVANTAGES OF 3 PHASE INDUCTION MOTOR
- PROBLEMS IN 3 PHASE INDUCTION MOTOR
- PROTECTIONS FOR 3 PHASE INDUCTION MOTOR
CHAPTER FIVE
- CONCLUSION
- REFERENCES
A 150–300 word synopsis of the main objectives, methods, findings, and conclusions of the Design And Construction Of A Single Phase Power Supply For A Three Phase Induction Motor should be included in the abstract.
Every chapter, section, and subsection in the research work should be listed in the Table of Contents, including the page numbers that correspond to each one.
The background, research question or hypothesis, and objective or aim of the Design And Construction Of A Single Phase Power Supply For A Three Phase Induction Motor should all be presented in the introduction, which is the first section.
A survey of previously conducted research on Design And Construction Of A Single Phase Power Supply For A Three Phase Induction Motor should be included in the literature review, together with an overview of the main conclusions, a list of any gaps, and an introduction to the current study.
The conclusion part should address the implications of the study, provide an answer to the research question and summarize the key findings.
The reference of Design And Construction Of A Single Phase Power Supply For A Three Phase Induction Motor, which should be formatted following a particular citation style (such as APA, MLA, or Chicago), is a list of all the sources cited in the title.
Other important sections of the Design And Construction Of A Single Phase Power Supply For A Three Phase Induction Motor should include the Title page, Dedication, Acknowledgments, Methodology, Results, Discussion, Appendices, Glossary, or Abbreviations List where applicable.