Design And Construction Of A Sequential Device Control Using Tv Remote Control
This research work on “Design And Construction Of A Sequential Device Control Using Tv Remote Control” is available in PDF/DOC. Click the below button to request or download the complete material
ABSTRACT
This work is on sequential device control using TV remote control. This device lets one to switch ON and switch OFF up to nine devices sequentially from your TV remote control.
The circuit consists of an IR sensor module TSOP1738, which is equivalent to TSOP1238. The output of TSOP1738 is fed to the trigger input (pin 2) of IC NE555 (IC1) via LED1. IC1 is wired in monostable mode and its output is fed to clock input of IC CD4017 (IC2). All the nine outputs of IC2 are connected to the bases of relay-driver transistors T1 through T9 that controls the loads via resistors R7 through R15, respectively. Relays RL1 through RL9 are connected between the positive terminal of 12V and collectors of respective transistors.
TABLE OF CONTENTS
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWLEDGEMENT
ABSTRACT
TABLE OF CONTENT
A 150–300 word synopsis of the main objectives, methods, findings, and conclusions of the Design And Construction Of A Sequential Device Control Using Tv Remote Control should be included in the abstract.
Every chapter, section, and subsection in the research work should be listed in the Table of Contents, including the page numbers that correspond to each one.
The background, research question or hypothesis, and objective or aim of the Design And Construction Of A Sequential Device Control Using Tv Remote Control should all be presented in the introduction, which is the first section.
A survey of previously conducted research on Design And Construction Of A Sequential Device Control Using Tv Remote Control should be included in the literature review, together with an overview of the main conclusions, a list of any gaps, and an introduction to the current study.
The conclusion part should address the implications of the study, provide an answer to the research question and summarize the key findings.
The reference of Design And Construction Of A Sequential Device Control Using Tv Remote Control, which should be formatted following a particular citation style (such as APA, MLA, or Chicago), is a list of all the sources cited in the title.
Other important sections of the Design And Construction Of A Sequential Device Control Using Tv Remote Control should include the Title page, Dedication, Acknowledgments, Methodology, Results, Discussion, Appendices, Glossary, or Abbreviations List where applicable.