The Effects Of Aggregate Sizes On The Concrete Strength (PDF/DOC)
In the sense that the materials involved in this project were capital intensive more especially cement, so in carrying out the work one must hsve to be careful in the selection and collection of materials to be used in the casting of the concrete.
The materials used are coarse aggregate (granite) fine aggregate (sand). The coarse aggregates used in this work were collected from ishiagu while the fine aggregate was collected in front of the carpentry’s workshop on the campus.
The test conform to the standard method test, the ratio used was 1:2:4 and the method adopted was batching by weight, from the mix ratio the relative weight for each material to be used for concrete cube cast was 36, these cubes were tested for compressive strength of 7, 14 and 28 days.
The results of tests involved in the work and that of compressive strength tests were calculated and tabulated as shown in the final tabulation of results.
With the above information, I now recommend and therefore conclude.
THE PROJECT OBJECTIVES
The project has some aims of verification. One of the most important purposes of this project is to compare the strength of concrete made with granite of different sizes eg 20, 15, 10 and 5mm. These same types of concrete are made under the same mix proportion.
Another purpose also is to know the compressive strength of concrete at different ages.
2.0 LITERATURE REVIEW
2.1 Introduction
The chapter presents a review of related literature that supports the current research on the Effects Of Aggregate Sizes On The Concrete Strength, systematically identifying documents with relevant analyzed information to help the researcher understand existing knowledge, identify gaps, and outline research strategies, procedures, instruments, and their outcomes…
Title page
Latter of transmittal
Approval page
Dedication
Acknowledgement
Abstract
Table of contents
CHAPTER ONE
1.1 The project objectives
CHAPTER TWO
2.1 Materials for concrete
2.2 Aggregates introduction
2.2.1 Fine Aggregate/Sand
2.2.2 Coarse Aggregate/Granite
CHAPTER THREE
3.0 Mixing of the concrete
CHAPTER FOUR
4.0 Preparation for placing and compaction
CHAPTER FIVE
5.0 Curing
CHAPTER SIX
6.0 Testing of hardened concrete and tabulation of results
CHAPTER SEVEN
7.0 Conclusions and recommendation
Bibliography.
This Research Work On “Effects Of Aggregate Sizes On The Concrete Strength” Complete Material Can Be Downloaded Through Whatsapp, Email Or Download Link. Click The Below Button To Proceed:
This study on the Effects Of Aggregate Sizes On The Concrete Strength is solely for academic research purposes only and should be used as a research guideline or source of ideas. Copying word-for-word or submitting the entire project work to your school is unethical academic behavior and “UniProjects” is not part of it.