Production of alkali using local raw material (palm inforescence)
The project aims to develop a flow process to obtain the optimum temperature and time necessary for the maximum recovery of alkali present in palm inflorescence.
On this ground, a preliminary experiment was performed. During this process, both male and female palm inflorescence were compared for maximum alkali production and it was observed that the female palm inflorescence produced highest quantity of alkali than the male palm inflorescence. Based on this, the female palm inflorescence was used in performing the experiment.
Also, experiments were carried out to determine the optimum temperature and time for maximum alkali recovery. After the analysis and analytical calculations it was found that the optimum temperature for maximum alkali production is 4500c and the corresponding time for the production is 90 minutes.
NOTE: Preview the following Table of Content before you download the full content. WYSIWYG – What You See Is What You Get.
Title page
Letter of transmittal
Dedication
Acknowledgement
Abstract
Table of content
1.0 CHAPTER ONE
INTRODUCTION
1.1 Need for local production of Alkali
2.0 CHAPTER TWO –
LITERATURE REVIEW
2.1 Oil palm tree (description)
2.1.1 Classification of palm and location
2.1.2 Oil palm: Historical review
2.2 Palm inflorescence
CHAPTER THREE
3.0 Experimental procedure
CHAPTER FOUR
Experimental results
CHAPTER SIX
Conclusion
CHAPTER SEVEN
Recommendation
References
CHAPTER EIGHT
Appendixes
This “Production of alkali using local raw material (palm inforescence)” file contains 8 Chapters, 85 Pages and 8,424 Words.
The author of Production of alkali using local raw material (palm inforescence) is written at the front page of the downloaded file.
To download this Production of alkali using local raw material (palm inforescence) full file, click on “Download File” on top of this page and follow the next.