Fabrication Of A Standard Wheelbarrow
The project is about fabrication of wheel-barrow, which is fabricated in Mechanical Engineering workshop in Institute of Management and Technology, Enugu.
The report comprises seven chapters. Chapter one is about the introduction of the wheel. Chapter two is about the literature review, chapter three is about the material selection and analysis/ manufacturing processes.
Chapter four is about construction of the prototype and optimization /maintenance. Chapter five is about testing one evaluation. Chapter six is about costing analysis conclusion and recommendation while chapter seven talks about references.
NOTE: Preview the following Table of Content before you download the full content. WYSIWYG – What You See Is What You Get.
Title page ii Letter of transmittal iii
Release page iv
Approval page v
Dedication vi
Acknowledgment vii
Abstract viii
Table of content ix
CHAPTER ONE
Introduction 1
CHAPTER TWO
Literature Review 2
CHAPTER THREE
Material selection and analysis 4
Manufacturing processes 8
CHAPTER FOUR
Construction of the prototype 14
Optimization/ maintenance 14
CHAPTER FIVE
Testing and evaluation 18
Costing analysis 18
CHAPTER SIX
Conclusion and recommendation 21
Reference 23
This “Fabrication Of A Standard Wheelbarrow” file contains 6 Chapters, 31 Pages and 3,301 Words.
The author of Fabrication Of A Standard Wheelbarrow is written at the front page of the downloaded file.
To download this Fabrication Of A Standard Wheelbarrow full file, click on “Download File” on top of this page and follow the next.