Design And Construction Of An Automatic Voltage Stabilizer
In the world today, the use of power supply in electronics equipment and gadgets has increased and it is still increasing. These power supplies are not stable as required by these electronics.
This arise the need for the power stabilization as to overcome this problem
This project handles this problem very well. Some recommendations were also made on this topic and student and users of electronics equipment will find them useful.
NOTE: Preview the following Table of Content before you download the full content. WYSIWYG – What You See Is What You Get.
Cover Page
Title Page
Approval Page
Dedication
Acknowledgment
Abstract
Table Of Contents
Chapter One
1.0 Introduction
Chapter Two
2.0 Literature Review
2.1 The Aims/Purpose
2.2 Stages In The Development Of Voltage Stabilizer
2.3 Stabilizer Grading
2.4 Application
Chapter Three
3.0 Basic Theory Of Components Us Ed
3.1 Transistors
3.2 Diode
3.3 Resistor
3.4 Relay
3.5 Zener Diode
3.6 Capacitor
3.7 Transformer
3.8 Fuse
3.9 Other Materials Us Ed
Chapter Four
4.0 Design, Construction And Operation Of The Stabilizer
4.1 Design/Construction
4.2 The Transformer Stage
4.3 Control Stage
4.4 The Relay Stage
4.5 Operation
4.6 Transformer Stage
4.7 Control Stage
4.8 Relay Stage
Chapter Five
5.0 Discussion, Conclusion And Recommendation
5.1 Discussion
5.2 Conclusion
5.3 Recommendation
Chapter Six
6.0 Cost Analysis, References
6.1 Cost Analysis
References
This “Design And Construction Of An Automatic Voltage Stabilizer” file contains 6 Chapters, 34 Pages and 3,783 Words.
The author of Design And Construction Of An Automatic Voltage Stabilizer is written at the front page of the downloaded file.
To download this Design And Construction Of An Automatic Voltage Stabilizer full file, click on “Download File” on top of this page and follow the next.