Design And Construction Of An Arc Welding Machine
The machine is designed to serve with an output of 250A. it has two pats which are the primary and secondary parts. The primary part, through which voltage is supplied to the machine has 180 turns which is made of 2mm2 S.W.G 14 copper coil. The secondary part has 45 turns made of 4mm2 S.W.G 8 copper coil.
Both turns are wound on separate limb of the laminated core. The voltage from primary turns flows to the secondary turn by induction.
The machine contain a power switch through which the machine can be switched on or off when connected to the power source. The indication light simply shows when the machine is on or off which is equally controlled by the power switch.
The fan connected to the machine helps in the looking of the temperature of the machine, it gets started once the machine is on.
The welding current is adjusted by varying the spacing between the primary and secondary windings when the cranks is rotated, clockwise the insulating block between the two winding moves down, the magnetic flux leakage and the inductive impedance are increased, thereby reducing the welding current in the secondary windings. Also as the insulating block is moved upward, away between the two turns, the magnetic flux leakage and the inductive impedance are brought down, causing the welding current to rise.
NOTE: Preview the following Table of Content before you download the full content. WYSIWYG – What You See Is What You Get.
Title Page/Approval Page
Certification
Dedication
Acknowledgement
Abstract
Table Of Content
Chapter One
1.0 Introduction
1.1 Aims/Objective
1.2 Scope Or Limitation
1.3 Definition Of Terms
Chapter Two
2.0 Literature Review
2.1 Transformer Design
2.2 Coil Design
2.3 Core Design
2.4 Equivalent Circuit Of The Machine
2.5 Machine Design
2.6 Operation Of Machine
2.7 Leakage Flux Reduction
2.8 Specification From Design
Chapter Three
3.0 Construction
3.1 Lamination
3.2 Transformer Former
3.3 Copper Coil
3.4 Insulating Materials
3.5 Methodology
3.6 Casing
3.7 Coupling
3.8 Electrical Holder
Chapter Four
4.0 Testing And Finding
4.1 Open-Circuit Test
4.2 Short-Circuit Test
4.3 Test Analysis
4.4 Conditions For Operation
4.5 Cost Analysis
Chapter Five
5.0 Conclusion
5.1 Recommendation
References
This “Design And Construction Of An Arc Welding Machine” file contains 5 Chapters, 50 Pages and 4,511 Words.
The author of Design And Construction Of An Arc Welding Machine is written at the front page of the downloaded file.
To download this Design And Construction Of An Arc Welding Machine full file, click on “Download File” on top of this page and follow the next.