Design And Construction Of A 12 Volts Automatic Battery Charger
A battery charger is an electrical device employed for charging batteries. This batteries that are usually charged by battery changer are the storage battery charger are the storage batteries also known as “accumulator” the battery changer changes. The alternating current form the power line into d.c suitable for charging.
When the battery is fully changed, is up to it’s maximum, 12 volt, the charger with automatically stop changing with the help of the contact relay, the transistor and the zener diode when bend the current back to the system.
NOTE: Preview the following Table of Content before you download the full content. WYSIWYG – What You See Is What You Get.
Title Page
Approval Page
Dedication
Acknoweldgement
Abstrct
Table Of Content
Chapter One
1.1 Introduction
1.2 Storage Battery/Method Of Charging
Chapter Two
2.0 Component Of The Power
2.1 Supply Unit
2.2 The Rectifying Unit
2.3 The Smoothing Unit
2.4 The Regulator And Regulated
2.5 D.C Charging Unit
Chapter Three
3.0 Circuit Design/Diagrams
3.1 The Casing
3.2 Ful Wave Rectification (Positive Half Wave)
3.3 The Bridge Rectification
3.4 The Block Diagram
3.5 T Hje Circuit Diagram
3.6 The Construction
Chapter Four
4.0 Tests And Operations
4.1 Battery Charging
4.2 Diagram Of Charging And Discharging Curves
4.3 Indication F Fully Charged Battery
Chapter Five
5.1 Summary
5.2 Constraints
5.3 Conclusions
5.4 Suggestions
5.5 Cost Of Production
References
This “Design And Construction Of A 12 Volts Automatic Battery Charger” file contains 5 Chapters, 45 Pages and 5,319 Words.
The author of Design And Construction Of A 12 Volts Automatic Battery Charger is written at the front page of the downloaded file.
To download this Design And Construction Of A 12 Volts Automatic Battery Charger full file, click on “Download File” on top of this page and follow the next.