Construction Of A Microcontroller Based Gate
T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the pedestrians a right of the way at intervals rather than being struck down when in a hurry to cross the roads. Such an electrical system with a touch of electronics that control the flow of traffic in a pre-determined sequential pattern at a junction, has its diagram comprising of different components. The power supply unit provides the control unit with specified voltage from primary source. The pulse generator consisting of a timer generates pulse for the system. The clock or counter moderates the signal that enters the decoding logic system. The display unit of each stand consists of led, the first is red in colour, the second is amber in colour and the last is green in colour.
NOTE: Preview the following Table of Content before you download the full content. WYSIWYG – What You See Is What You Get.
Title Page
Certification
Dedication
Acknowledgement
Abstract
Table of Contents
List of Figures
CHAPTER ONE
INTRODUCTION
1.1 Background of the Study
1.2 Objective of the Project
1.3 Scope of the Study
1.4 Project Report Organization
CHAPTER TWO
LITERATURE REVIEW
2.1 Introduction
2.2 Pre-Emption And Priority
2.3 Special Provisions
2.4 Technology
2.5 Control And Co-Ordination
2.6 Design Layout And Operation Site
CHAPTER THREE
DESCRIPTION OF SYSTEMS
3.1 The Power Supply
3.2 The Voltage Regulator
3.3 Crystal Oscillator
3.4 Paper Capacitor
3.5 The Microcontroller
3.6 System Flow Diagram
3.7 Light Indicator Stage
3.8 Transistors
3.9 Resistors
3.10 Bridge Rectifier
3.11 Electrolytic Capacitor
3.12 Step Down Transformer
3.13 Seven Segment Display
CHAPTER FOUR
SYSTEMS OPERATIONAL UNITS
4.1 The Control Unit
4.2 System Analysis
4.3 Choice Of Counter
4.4 The Interface Unit
4.5 Test And Result
4.6 Observation
4.7 Packaging
4.8 Bill Of Engineering Measurement And Evaluation
CHAPTER FIVE
CONCLUSION AND RECOMMENDATIONS
5.1 Conclusion
5.2 Recommendations
5.3 Suggestions For Further Research
References
This “Construction Of A Microcontroller Based Gate” file contains 5 Chapters, 73 Pages and 8,754 Words.
The author of Construction Of A Microcontroller Based Gate is written at the front page of the downloaded file.
To download this Construction Of A Microcontroller Based Gate full file, click on “Download File” on top of this page and follow the next.