Audio Visual IR Sensor Tester
This research work on “Audio Visual IR Sensor Tester” is available in PDF/DOC. Click the below button to request or download the complete material
Most of the Remote control systems use TSOP 1738 IR Sensor module to control various functions. This IR Sensor is highly sensitive and may damage easily, if is supply voltage increases above 6 volts. This tester is useful to check the working of the IR Sensor. It gives audio-visual indications when the IR sensor is working properly.
TSOP 1738 is designed to sense 38 kHz pulsed infrared rays used in remote handsets.
The IR Sensor has a PN photodiode and a preamplifier stage encased in an epoxy case. The case acts a filter and allows only IR rays to pass through it. The sensor is equipped with an AGC, band pass filter, a demodulator and a control circuit. The output of the sensor has a bipolar transistor with 80-100 K resistor in its collector. The output gives 5 volts at 5 mA current in the standby mode and the output sinks current when the sensor gets pulsed IR Rays. This sensor is capable of continuous data transmission up to2400 bps or more. The band pass filter and AGC circuits suppress unexpected noise to prevent false triggering. The sensor responds to the IR rays only if the carrier frequencyis close to the centre frequency of the band pass filter.
Fig. 1: Image of TSOP 1738 IR Sensor
The IR Sensor tester is powered by two 3 volts lithium cells. The sensor module is tested using the Test socket. Alternately you can use 3 mini alligator clips for on board testing. When the switch S1 is turned on, LED and buzzer remains off, if the IR sensor is good. When the remote handset is focused on to the sensor, and any of the buttons is pressed, LED blinks in sympathy with the pulsed IR rays and buzzer beeps. This indicates that the sensor is good.
A good sensor will give high output when it is not receiving IR rays. This high output makes the cathode of LED and the negative of buzzer high and they remain off. When the output of the sensor turns low by receiving the IR rays, LED and buzzer turns on.
Fig. 2: Image of a Button Cell Battery
Use a 3-12 volt mini buzzer and 3 mm LED to make the gadget compact. It can be enclosed in a small case.
A 150–300 word synopsis of the main objectives, methods, findings, and conclusions of the Audio Visual IR Sensor Tester should be included in the abstract.
Every chapter, section, and subsection in the research work should be listed in the Table of Contents, including the page numbers that correspond to each one.
The background, research question or hypothesis, and objective or aim of the Audio Visual IR Sensor Tester should all be presented in the introduction, which is the first section.
A survey of previously conducted research on Audio Visual IR Sensor Tester should be included in the literature review, together with an overview of the main conclusions, a list of any gaps, and an introduction to the current study.
The conclusion part should address the implications of the study, provide an answer to the research question and summarize the key findings.
The reference of Audio Visual IR Sensor Tester, which should be formatted following a particular citation style (such as APA, MLA, or Chicago), is a list of all the sources cited in the title.
Other important sections of the Audio Visual IR Sensor Tester should include the Title page, Dedication, Acknowledgments, Methodology, Results, Discussion, Appendices, Glossary, or Abbreviations List where applicable.