Construction Of Grain Grinding Machine
This research work on “Construction Of Grain Grinding Machine” is available in PDF/DOC. Click the below button to request or download the complete material
The aim of the project is to construct a domestic grain grinding machine to be powered by electric motor through pulley and belt transmission.
The project is to perform mostly blending and grinding on grains e.g beans, maize, melon, millet and such other food crops.
In construction of the project, there are various factors that is being put into consideration.
i. The size specification
ii. The power of the electric motor to be used
iii. The domestic operation which can be performed by the machine.
iv. The capacity of the machine.
INTRODUCTION
Every year, the final year student of this institution in Higher National Diploma (HND) and the National Diploma (ND) into practice.
This is aimed at justifying the emphasis lead on practical work during the course of study in the assigned to construct a grain-grinding machine by the machine committee of Mechanical Engineering Department, the Polytechnic, Enugu.
A grain grinding machine is an equipment used for grinding maize, beans, melon, millet and such other good crops. This equipment comprises essentially of an electric motor, belt, pulley, transmission shaft, hopper, mills, spiral conveyor and stands. These alleviate the rigours and problems house we encounter when grinding beans for the good stuff.
1.1 RESEARCH PROBLEMS
The project research problem are:
i. To construct a local fabricated grain grinding machine using available local technology.
ii. To construct a machine with a size specification.
iii. To construct a machine which can perform a domestic operations.
iv. To construct a machine which have adequate capacity, lighter in weight, lesser fatigue and portable.
1.2 JUSTIFICATION OF STUDY
i. This is to promote indigenous machine and their producers.
ii. To have a portable grain grinding machine constructed for domestic uses with a powered driven source.
iii. To improve the economic and the country as a whole by neglecting imported blenders i.e producing machine that is affordable to substitute the imported blenders.
iv. To be able to meet National Board for Technical Education (NBTE) requirement in awarding National Diploma (ND) in Mechanical Engineering.
1.3 OBJECTIVES OF THE STUDY
The objectives of the study are:-
i. To construct grain grinding machine with local materials.
ii. To construct a machine which is less in crop and domestic usage.
iii. To produce a grain grinding machine that is lesser in vibration, weight and in size.
1.4 SCOPE AND LIMITATION
The following are the scope and limitation of the project:
To construct a machine that can perform domestic grinding of food condiments.
It can perform any operation that the electrical blender can perform due to its electrically powered.
Title page ii
Approval page iii
Certification iv
Dedication v
Acknowledgment vi
Abstract viii
Table of content ix
CHAPTER ONE
Introduction 1
1.1 Research problem 1
1.2 Justification of the study 2
1.3 Objectives of the study 3
1.4 Scope and limitation 3
CHAPTER TWO
Literature review 5
Existing grinding machine 7
CHAPTER THREE
Description of the machine 9
CHAPTER FOUR
Analysis and size specification 15
Calculation analysis 19
CHAPTER FIVE
Maintenance 25
Operation procedure 25
CHAPTER SIX
Conclusion 27
Recommendation for further work 28
Reference 30